Appliance, plumbing, and cleaning problems in the kitchen.
34 guides
If the display and buttons work but no water ever enters, the water supply valve behind the machine, a stuck float switch, or the inlet valve itself is almost always the cause.
When only the top rack comes out dirty, the upper spray arm usually isn't getting enough water pressure or is physically blocked — the lower rack working fine rules out the pump itself.
A cycle that eventually finishes but takes noticeably longer than it used to is usually the soil sensor adding wash time, a heating delay, or a partially restricted water supply.
A dishwasher that stops mid-cycle with power still on usually traces back to the door latch, a thermal safety trip, or a control board fault, whether it happens early or partway through.
A spray arm that won't turn is almost always physically blocked — by a tall dish, food debris in the nozzles, or a jam where it clips onto its water feed.
A whole or half-dissolved pod left in the dispenser usually means the dispenser door didn't open, water isn't hot enough, or the spray arm isn't reaching it directly.
Plastic staying wet while glass and ceramic come out dry isn't a fault — it's a basic property of plastic that rinse aid and loading position can meaningfully improve.
A buzzing sound that doesn't stop the machine from running is usually the drain valve solenoid, a vibrating panel, or the motor working harder than normal — not the same as a grinding jam.
A fine gritty or sandy feel — distinct from visible food bits or a cloudy film — usually means a damaged filter is letting debris recirculate rather than catching it.
Visible bits of food left on 'clean' dishes almost always trace back to a dirty filter, overloading, or a blocked spray arm — the same three checks resolve most cases.
Water escaping at the base of the door during a cycle points to a worn door seal, oversudsing, or overfilling — and needs prompt attention given how close it runs to electrical connections.
A cycle that truly never ends, rather than just running long, usually means a soil sensor or heating circuit is stuck reporting a condition that's never satisfied.